Page 1 of 1
[closed] Command line options?
Posted: Thu Apr 06, 2006 1:26 pm
by MKairys
I see by experimentation I can invoke winsync3 via command line and include the name of a session or project, as with v. 2.
What about other switches? In particular I would like to see /I, to show immediately the "preview".
Posted: Thu Apr 06, 2006 2:25 pm
by Wilhelm
The switch /I was replaced by /scan. Look in the readme.chm for command line options.
Posted: Thu Apr 06, 2006 2:37 pm
by MKairys
Thanks, I missed that link in the file (winsync3.chm).
Posted: Thu Apr 06, 2006 2:51 pm
by Wilhelm
The archive of the latest build 1171 contains only a "readme.chm" which is actually the winsync3.chm. Did not cause any confusion, did I?
Posted: Thu Apr 06, 2006 2:58 pm
by MKairys
Well, I confess to being a bit confused, but it wasn't your doing
Hopefully the renaming of winsync3.chm to readme.chm implies there will be a "real" winsync3.chm soon...
Posted: Thu Apr 06, 2006 3:05 pm
by Wilhelm
MKairys wrote:Hopefully the renaming of winsync3.chm to readme.chm implies there will be a "real" winsync3.chm soon...
... and a "real" winsync3.exe, too.
Even though the alpha does already a nice job.
Posted: Thu Apr 06, 2006 4:14 pm
by grigsoft
Of course, full help is on the way
Posted: Mon Apr 24, 2006 11:34 pm
by MKairys
Wilhelm wrote:The switch /I was replaced by /scan. Look in the readme.chm for command line options.
This option is not listed in the latest documentation (build 1180) although it does work...
Posted: Tue Apr 25, 2006 4:15 am
by grigsoft
Thank you, you are right.