[closed] Command line options?

Discussion of new Synchronize It! version.
Post Reply
MKairys
Posts: 63
Joined: Tue Oct 07, 2003 10:28 am
Location: Ann Arbor, Michigan

[closed] Command line options?

Post by MKairys »

I see by experimentation I can invoke winsync3 via command line and include the name of a session or project, as with v. 2.

What about other switches? In particular I would like to see /I, to show immediately the "preview".

Wilhelm

Post by Wilhelm »

The switch /I was replaced by /scan. Look in the readme.chm for command line options.

MKairys
Posts: 63
Joined: Tue Oct 07, 2003 10:28 am
Location: Ann Arbor, Michigan

Post by MKairys »

Thanks, I missed that link in the file (winsync3.chm).

Wilhelm

Post by Wilhelm »

The archive of the latest build 1171 contains only a "readme.chm" which is actually the winsync3.chm. Did not cause any confusion, did I?

MKairys
Posts: 63
Joined: Tue Oct 07, 2003 10:28 am
Location: Ann Arbor, Michigan

Post by MKairys »

Well, I confess to being a bit confused, but it wasn't your doing :wink:

Hopefully the renaming of winsync3.chm to readme.chm implies there will be a "real" winsync3.chm soon...

Wilhelm

Post by Wilhelm »

MKairys wrote:Hopefully the renaming of winsync3.chm to readme.chm implies there will be a "real" winsync3.chm soon...
... and a "real" winsync3.exe, too. :D Even though the alpha does already a nice job.

grigsoft
Site Admin
Posts: 1673
Joined: Tue Sep 23, 2003 7:37 pm
Contact:

Post by grigsoft »

Of course, full help is on the way :)

MKairys
Posts: 63
Joined: Tue Oct 07, 2003 10:28 am
Location: Ann Arbor, Michigan

Post by MKairys »

Wilhelm wrote:The switch /I was replaced by /scan. Look in the readme.chm for command line options.
This option is not listed in the latest documentation (build 1180) although it does work...

grigsoft
Site Admin
Posts: 1673
Joined: Tue Sep 23, 2003 7:37 pm
Contact:

Post by grigsoft »

Thank you, you are right.

Post Reply