Page 1 of 1

Command Line Parameter for "Include all folders"

Posted: Mon Feb 22, 2010 12:40 pm
by Spitfire_ch
Hi,

I recently started to invoke Synchronize It! directly from TotalCommander. This is highly convenient. I somehow didn't find a parameter to choose "include subfolders -> include all folders" (which usually is my default setting). Currently, I use the following parameters:

"%P\" "%T\" /sync /R /XD"" /smart

/XD"" (exclude no folders) kind of does the trick of making sure no subfolders are filtered or excluded. But it would be nicer if there was a parameter to directly choose "include all folders". Maybe it's already there and I am just blind ;)

Thank you and best regards

- spitfire

Re: Command Line Parameter for "Include all folders"

Posted: Mon Feb 22, 2010 7:07 pm
by grigsoft
No, you are not blind :) this is default state, so there is no switch for this. But as you correctly pointed out, if last session of used with filter, there is no way to clear it. I will add some switch for this.

Re: Command Line Parameter for "Include all folders"

Posted: Mon Feb 22, 2010 7:46 pm
by Spitfire_ch
Great, thank you very much! :)