Command Line Parameter for "Include all folders"

Post your new features ideas and suggestions here.
Post Reply
Spitfire_ch
Posts: 84
Joined: Mon May 21, 2007 9:11 am
Location: Basel, Switzerland

Command Line Parameter for "Include all folders"

Post by Spitfire_ch »

Hi,

I recently started to invoke Synchronize It! directly from TotalCommander. This is highly convenient. I somehow didn't find a parameter to choose "include subfolders -> include all folders" (which usually is my default setting). Currently, I use the following parameters:

"%P\" "%T\" /sync /R /XD"" /smart

/XD"" (exclude no folders) kind of does the trick of making sure no subfolders are filtered or excluded. But it would be nicer if there was a parameter to directly choose "include all folders". Maybe it's already there and I am just blind ;)

Thank you and best regards

- spitfire

grigsoft
Site Admin
Posts: 1673
Joined: Tue Sep 23, 2003 7:37 pm
Contact:

Re: Command Line Parameter for "Include all folders"

Post by grigsoft »

No, you are not blind :) this is default state, so there is no switch for this. But as you correctly pointed out, if last session of used with filter, there is no way to clear it. I will add some switch for this.

Spitfire_ch
Posts: 84
Joined: Mon May 21, 2007 9:11 am
Location: Basel, Switzerland

Re: Command Line Parameter for "Include all folders"

Post by Spitfire_ch »

Great, thank you very much! :)

Post Reply