Commandline option for changes only

Post your new features ideas and suggestions here.
Post Reply
MKairys
Posts: 63
Joined: Tue Oct 07, 2003 10:28 am
Location: Ann Arbor, Michigan

Commandline option for changes only

Post by MKairys »

I use the "changes only" button quite a bit; I would like to be able to invoke CompareIt in that mode from the command line and save the extra click :)

grigsoft
Site Admin
Posts: 1673
Joined: Tue Sep 23, 2003 7:37 pm
Contact:

Post by grigsoft »

I was thinking of making this mode sticky - ie if you quit with this option ON, it will be ON on next start. But adding switch is even less problem.

MKairys
Posts: 63
Joined: Tue Oct 07, 2003 10:28 am
Location: Ann Arbor, Michigan

Post by MKairys »

grigsoft wrote:...if you quit with this option ON, it will be ON on next start...
I actually think I wouldn't like that... I think because for me, it's only in some specific scenarios that I would want to start that way - when checking source code in to a SCC system for example. Usually I would want to see the full display.

grigsoft
Site Admin
Posts: 1673
Joined: Tue Sep 23, 2003 7:37 pm
Contact:

Post by grigsoft »

OK, I will add just a cmdline key for now.

grigsoft
Site Admin
Posts: 1673
Joined: Tue Sep 23, 2003 7:37 pm
Contact:

Post by grigsoft »


MKairys
Posts: 63
Joined: Tue Oct 07, 2003 10:28 am
Location: Ann Arbor, Michigan

Post by MKairys »

Thank you very much!

Post Reply