Commandline option for changes only

MKairys · Post by **MKairys** » Tue Nov 21, 2006 6:53 pm

I use the "changes only" button quite a bit; I would like to be able to invoke CompareIt in that mode from the command line and save the extra click

Post by **grigsoft** » Wed Nov 22, 2006 7:37 am

I was thinking of making this mode sticky - ie if you quit with this option ON, it will be ON on next start. But adding switch is even less problem.

MKairys · Post by **MKairys** » Wed Nov 22, 2006 11:13 am

grigsoft wrote:...if you quit with this option ON, it will be ON on next start...

I actually think I wouldn't like that... I think because for me, it's only in some specific scenarios that I would want to start that way - when checking source code in to a SCC system for example. Usually I would want to see the full display.

Post by **grigsoft** » Wed Nov 22, 2006 11:21 am

OK, I will add just a cmdline key for now.

Post by **grigsoft** » Wed Nov 22, 2006 8:21 pm

http://grigsoft.com/blog/?p=43

MKairys · Post by **MKairys** » Wed Nov 22, 2006 10:10 pm

Thank you very much!