SynchronizeIt! - Auto Execute Configs and Projects
SynchronizeIt! - Auto Execute Configs and Projects
I would love to see the ability to run Configs or Projects from the command line with /Auto. So far my experience has been that if I enter a Config or Project name after Winsin on the command line and include the /Auto switch, I get an error message that specific input and output paths are required. What I want to do is a nightly synchronization of multiple directories. The entire task is described in a Project. I want to use the Windows Scheduled Tasks capability to run winsin off-hours and execute the project. Can this be done?
My Mistake
It absolutely works as it should. What I did not do was put a / before the Project name. or use the /P=Project name. I had just done winsin.exe Project /auto. Thanks so much for your prompt reply.
Pull model
Can your software be used in a pull model?
i.e., I have many clients that need to have a set of updated files in their local folders. I was thinking of using CVS as the repository and allow the clients to pull a module via a scheduler. Can Synchronize it! works from the clients and do unattended pull based on a schedule? TIA for your help.
i.e., I have many clients that need to have a set of updated files in their local folders. I was thinking of using CVS as the repository and allow the clients to pull a module via a scheduler. Can Synchronize it! works from the clients and do unattended pull based on a schedule? TIA for your help.