My configuration:
Laptop with Wlan 11n, actually connected with 270Mbps brutto
Wireless router with two NAS sets attached to it, connected as S: and V:
I start Synchronize It!
In the "select Folders" window I enter:
S:\Projects (contains 1067 folders and 26839 files)
V:\Projects ( contains nearly the same)
Press the "Preview" button
Now I see in the lower left hand corner the staus "Ready".
in the lower right hand corner all the symbols and above them the button "Cancel"
Nothing happens. I don't know wether the program is doing something or not, also the mouse cursor dos not change to the busy state.
When I open the Network Status window I can see a upcount of the transfered packets, so I assume there is something going on.
Would it be possible to give a message other than "Ready"?
e.g. a blinking "in Progress" or better, write down what the program ist doing exactly.
Now while I write this posting and drink a coffee in between the program Synchronize It! ist still doing something without feedback to the user for about 10 minutes.
syntoh
The Status Bar does not show the porgrams action
I repeated the same process with a smaller folder as source. After about 15 sec. there is exactly to see what you wrote down, names of folders are to see there. But in the case of a very large structure with subfolders and files is nothing to see for a long time. In the example of my first posting was it "quite" for more then 20 min. But I am shure the program is always working during this period.grigsoft wrote:Normally near the Cancel button there should be changing names of folders, showing the progress.
The folder "Projects" ( noted in first posting) contains six sub folders, no files. The 26839 files are all in the six subfolders stored.grigsoft wrote: but in case of many files in root folder you may not see it. I will change this.
syntoh