The Status Bar does not show the porgrams action
Posted: Fri Apr 04, 2008 1:47 pm
My configuration:
Laptop with Wlan 11n, actually connected with 270Mbps brutto
Wireless router with two NAS sets attached to it, connected as S: and V:
I start Synchronize It!
In the "select Folders" window I enter:
S:\Projects (contains 1067 folders and 26839 files)
V:\Projects ( contains nearly the same)
Press the "Preview" button
Now I see in the lower left hand corner the staus "Ready".
in the lower right hand corner all the symbols and above them the button "Cancel"
Nothing happens. I don't know wether the program is doing something or not, also the mouse cursor dos not change to the busy state.
When I open the Network Status window I can see a upcount of the transfered packets, so I assume there is something going on.
Would it be possible to give a message other than "Ready"?
e.g. a blinking "in Progress" or better, write down what the program ist doing exactly.
Now while I write this posting and drink a coffee in between the program Synchronize It! ist still doing something without feedback to the user for about 10 minutes.
syntoh
Laptop with Wlan 11n, actually connected with 270Mbps brutto
Wireless router with two NAS sets attached to it, connected as S: and V:
I start Synchronize It!
In the "select Folders" window I enter:
S:\Projects (contains 1067 folders and 26839 files)
V:\Projects ( contains nearly the same)
Press the "Preview" button
Now I see in the lower left hand corner the staus "Ready".
in the lower right hand corner all the symbols and above them the button "Cancel"
Nothing happens. I don't know wether the program is doing something or not, also the mouse cursor dos not change to the busy state.
When I open the Network Status window I can see a upcount of the transfered packets, so I assume there is something going on.
Would it be possible to give a message other than "Ready"?
e.g. a blinking "in Progress" or better, write down what the program ist doing exactly.
Now while I write this posting and drink a coffee in between the program Synchronize It! ist still doing something without feedback to the user for about 10 minutes.
syntoh