Problem when comparing with CDRW

ubose · Post by **ubose** » Mon May 23, 2005 3:09 pm

When I first synchronize my data folders on a hard drive with a CDRW, all my folders are copied over as expected. But when I scan the same two source and destination again, it gives me my source folders as out of date. This is happening, I believe, because the folders on the CDRW got the current system date and time stamp. This is happening in spite of putting a check mark in the "Ignore date and time" checkbox. What is the solution? Thank you.

Post by **grigsoft** » Mon May 23, 2005 4:36 pm

Are you sure your files were copied correctly? Because when "Ignore date and time" check is used, files are compared binary, byte-by-byte, so it should be listed only if content differs